Teledyne-lecroy QPHY-DDR4 Uživatelský manuál stáhnout pdf (Strana 44)

After the completion of the SRIN_dIVW_R test the oscilloscope is in the following configuration:

Figure 29 - Oscilloscope Configuration after SRIN_dIVW_R Test

Shown on this screen:

• Z2 is a zoom of F2, the acquired DQS signal after any probe deskew has been applied. The zoom is

positioned at the location of the “worst case” SRIN_dIVWR measurement indicated by

t@SRINRmin. A trace label is applied on this trace according to the signal name assigned to

DQS. This signal is not measured in this test and is only provided as a visual reference.

• Z3 is a zoom of F3, the acquired DQ signal after any probe deskew has been applied. The zoom is

position at the location of the “worst case” SRIN_dIVWR measurement indicated by

t@SRINRmin. A trace label is applied on this trace according to the signal name assigned to DQ.

This is the signal which is measured in this test.

Figure 30 – SRIN_dIVW Test Results

44 924291 Rev A

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 72 73

Žádné komentáře

Teledyne-lecroy QPHY-DDR4 Uživatelský manuál Strana 44