Teledyne-lecroy PETracer ML Analyzer and Exerciser User Manual Uživatelský manuál stáhnout pdf (Strana 141)

PETracer ML User Manual Chapter 8: Recording Options

Teledyne LeCroy 133

• Up to two sets of Link Conditions or Ordered Sets per channel: If you place a

combination of three Link Conditions and Ordered Sets into three separate state

cells and then assign three different actions to each, an error results. 

Example: Place TS1 in the Global State cell and select Filter Out. Then place TS2

in Sequence 1, State 1 and select Advance the Sequence. Then add Link Active

to Sequence 1, State 2 and select Trigger. When you attempt to apply Trigger to

Link Active, an error message appears.

Example: Too many Link Conditions and Ordered Sets. In this example, the user

attempted to create a rule with three Link Conditions and Ordered Sets. The

maximum allowable Link Conditions and Ordered Sets is two.

• In two-unit setups, no cross-box sequencing is allowed: For example, you

cannot configure the first Analyzer to advance sequence on TLP and then configure

the second to trigger on a DLLP-ACK for this TLP. Actions apply to both Analyzers.

• Four different DLLPs per channel

• Three different TLPs per channel

• Four payload DWORD-checkers per channel

• One set of errors per channel

• One Timer event per channel

• Two Counters per channel

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 273 274

Žádné komentáře

Teledyne-lecroy PETracer ML Analyzer and Exerciser User Manual Uživatelský manuál Strana 141